This consolidation is unofficial and is for reference only.

For the official version of the regulations, consult the original documents on file with the Registry of Regulations , or refer to the Royal Gazette

Part II .

Regulations are amended frequently.

Please check the list of Regulations by Act to see if there are any recent amendments to these regulations filed with the Registry that are not yet included in this consolidation.

Although every effort has been made to ensure the accuracy of this electronic version, the Registry of Regulations assumes no responsibility for any discrepancies that may have resulted from reformatting.

This electronic version is copyright © 2010, Province of Nova Scotia , all rights reserved. It is for your personal use and may not be copied for the purposes of resale in this or any other form.

Designation of Temporary Work Areas Regulations

made under subsection 106B(2) of the

Motor Vehicle Act

R.S.N.S. 1989, c. 293

O.I.C. 2008-298 (May 28, 2008, effective June 1, 2008), N.S. Reg. 285/2008

as amended by O.I.C. 2010-295 (July 27, 2010), N.S. Reg. 120/2010

Citation

1 These regulations may be cited as the Designation of Temporary Work Areas Regulations .

Definitions for Act and regulations

(1) In these regulations,

“Act” means the Motor Vehicle Act ;

“temporary workplace” means an area of a roadway directly affected by

construction, maintenance, or utility operations;

“ Temporary Workplace Traffic Control Manual ” means the latest edition of

the Temporary Workplace Traffic Control Manual published by the

Department;

“utility operations” means construction or maintenance work involving

overhead lines or cables but no excavations, other than a hole bored in the

ground for a utility pole where there is no risk of vehicle entry into the hole.

(2) In

Section 106B of the Act and these regulations,” temporary work area” means the

portion of a temporary workplace where the primary work is being done.

Designation of temporary work area

(1) Except as provided in subsection (2), a temporary work area must be designated by

placing a TC-2 “Road Work” sign at the beginning of the temporary work area and a

TC-4 “Construction Ends” sign at the end of the temporary work area.

(2) Persons performing utility operations may substitute a TC-114(NS) “Overhead

Bucket Work” sign for the TC-2 “Road Work” sign required by subsection (1).

Subsection 3(2) amended: O.I.C. 2010-295, N.S. Reg. 120/2010.

(3) A TC-2 “Road Work” sign, a TC-4 “Construction Ends” sign and a TC-114(NS)

“Overhead Bucket Work” sign must be

Subsection 3(3) amended: O.I.C. 2010-295, N.S. Reg. 120/2010.

(

a) in the form consistent with the descriptions in the Temporary Workplace

Traffic Control Manual ; and

(

b) placed according to the latest Temporary Workplace Traffic Control Manual .